Catch, Adjusting
WARNING: This page is about a different variant/trim than selected.
NOTE:
The striker pin backing must be position with the pins -arrows- exactly in the hole.
The striker pins must be sheared off cleanly after sliding the striker pin.
-- Loosen the bolts -2-.
-- Slide the catch -1- until the door is flush with the body contours.
NOTE:
When adjusting the catch, move it only toward the center of the vehicle.
Do not adjust the door height using the catch because the door lock will be damaged.
-- The catch must align in door lock center for correct adjustment.
-- Tighten the bolts -2-.
- Tightening Specification. Refer to DOOR LOCK .