Lock Cylinder, Removing And Installing: Removing

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Lock Cylinder

Courtesy of AUDI OF AMERICA, LLC

-- Press the door seal to the side and remove the protective film over the hole -arrow A-.

-- Remove the locking bolt -4- as far as the stop using a screwdriver -1-.

-- Press the lock cylinder retaining bracket -3- inward.

-- Remove the lock cylinder -2- from the mounting bracket -arrow B-.

NOTE:

If the lock cylinder cannot be pressed out, slide the key into it and remove it with the key turned slightly.