Information Electronics Control Module 1 -J794-, Removing And Installing: Removing
WARNING: This page is about a different variant/trim than selected.
-- Insert the two clips from the Radio Removal Tool:T10057 into the slots on the Information Electronics Control Module 1 -J794- until they engage. Points on the grip eyelets of tool face outward.
Fig 1: Insert Two Clips From T10057 Into Slots On Information Electronics Control Module Until They Engage
-- Remove the Information Electronics Control Module 1 -J794- from the installation frame.
-- Remove the Radio Removal Tool:T10057 by pushing the locking tabs on Information Electronics Control Module 1 -J794-.
-- Release and disconnect the connectors from the Information Electronics Control Module 1 -J794-.
-- Insert the Fiber-Optic Repair Set - Connector Protective Caps:VAS6223 / 9 -1- onto the MOST Bus connector -2-.