Overview - EVAP System, Rest Of World Vehicles
WARNING: This page is about a different variant/trim than selected.
- Breather Line
- to the EVAP Canister Purge Regulator Valve 1 -N80-
- To disconnect, press release button on connection piece. Refer to CONNECTOR COUPLINGS, SEPARATING .
- Clipped into brackets under the vehicle underbody
- O-Ring
- Valve
- Breather Line
- From the fuel tank
- To disconnect, press release button on connection piece. Refer to CONNECTOR COUPLINGS, SEPARATING .
- Vent Line
- Vents to the outside at the left rear under the wheel housing liner
- EVAP Canister
- Installed location: on the left side at the back of the underbody under the cover
- Removing and Installing. Refer to EVAP CANISTER, REMOVING AND INSTALLING, REST OF WORLD VEHICLES .
- Bolt
- 16 Nm