Overview - EVAP Canister And Leak Detection System: Notes
WARNING: This page is about a different variant/trim than selected.
NOTE:
Through My 2012 the Leak Detection Pump -V144- is installed -Item 1- OVERVIEW - EVAP CANISTER AND LEAK DETECTION SYSTEM List Item:Leak Detection Pump -V144-.
From MY 2013 the Fuel Tank Leak Detection Control Module -J909- with integrated Fuel Tank Pressure Sensor -G400- is installed -Item 1- OVERVIEW - EVAP CANISTER AND LEAK DETECTION SYSTEM List Item:Leak Detection Pump -V144-.
- Leak Detection Pump -V144-
- From MY 2013 Fuel Tank Leak Detection Control Module -J909- with integrated Fuel Tank Pressure Sensor -G400-
- Installed location: on the left side at the back of the underbody under the cover
- Check in Guided Fault Finding mode using the Vehicle Diagnostic Tester.
- Leak Detection Pump -V144-, Removing and Installing (refer to LEAK DETECTION PUMP, REMOVING AND INSTALLING ) Fuel Tank Leak Detection Control Module -J909- with integrated Fuel Tank Pressure Sensor -G400- (refer to FUEL TANK LEAK DETECTION CONTROL MODULE WITH INTEGRATED FUEL TANK PRESSURE SENSOR, REMOVING AND INSTALLING ).
- Leak Detection System Air Filter, Removing and Installing. Refer to LEAK DETECTION SYSTEM AIR FILTER, REMOVING AND INSTALLING .
- Clamp
- Must be appropriate for the model type. Refer to the Parts Information..
- Vent Line
- Bolt
- 4 Nm
- Bolt
- 16 Nm
- Rubber Grommet
- Bushing
- EVAP Canister
- Installed location: in the bottom of the spare wheel well
- Removing and Installing. Refer to EVAP CANISTER, REMOVING AND INSTALLING .
- Breather Line
- To the locking flange on the fuel tank
- To disconnect, press release button on connection piece. Refer to CONNECTOR COUPLINGS, SEPARATING .
- Breather Line
- To the EVAP Canister Purge Regulator Valve 1 -N80-
- To disconnect, press release button on connection piece. Refer to CONNECTOR COUPLINGS, SEPARATING .
- Seal
- Vacuum Line
- To the engine