Remove Cylinder Bank 2 (Left)
WARNING: This page is about a different variant/trim than selected.
-- Remove the air filter housing. .
-- Remove the nuts -arrows- and then remove the air filter housing bracket -1-.
-- Remove the screws -1- and -2- from the connector strip.
-- Disconnect the connector -arrow-.
-- Push the connector toward the ignition coil, open the lock by hand and connect the connector to the ignition coils.
-- Move the wiring harness slightly down.
Continuation For Both Sides:
-- Place the ignition coil puller:T40039 only on the top rib -arrow- and pull the ignition coils one after the other off the spark plugs.
-- Remove spark plugs using spark plug wrench:VAS 3122B .