LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 50 (Maintenance, Diagnosis (Maintenance Procedures) (Coupe)) >> 03 Maintenance, Diagnosis >> Maintenance Procedures >> Spark Plugs, Replacing >> 6-Cylinder 3.0L TFSI Gasoline Engine >> Removing Cylinder Bank 1 (Right)

Removing Cylinder Bank 1 (Right)

WARNING: This page is about a different variant/trim than selected.

-- Remove the engine cover. Refer to ENGINE COVER, REMOVING .

-- Free up the fuel line -4- and the line -1- from the EVAP canister on the air filter housing and air duct pipe.

Fig 1: Free Up Fuel Line
GWWA10-11036Courtesy of AUDI OF AMERICA, LLC

-- Remove the vacuum hose -2-.

-- Remove the air duct pipe by loosening the hose clamp -3- and opening the clamps -arrows-.

-- Remove the air filter housing lower section. .

-- Remove the screws -arrows- from the connector strip.

Fig 2: CMP Sensor And Exhaust Camshaft Control Valve Cylinder Bank 1 (Right Side)
GWWA15-10639Courtesy of AUDI OF AMERICA, LLC

-- Push the connector toward the ignition coil, open the lock by hand and connect the connector to the ignition coils.

-- Move the wiring harness slightly down.

NOTE:

Ignore -1 and 2-.