Version 2 Removing

WARNING: This page is about a different variant/trim than selected.

-- Remove the engine cover. Refer to ENGINE COVER, REMOVING .

-- Remove the connector -1- for the heated oxygen sensor -G39- from the retainer.

Fig 1: Heated Oxygen Sensor -G39-

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Ignore -2 through 4-.

-- Unlock the connector -1 through 4- disconnect all connectors in -direction of arrow- from the ignition coils.

Fig 2: Disconnecting Ignition Coils Connectors

Courtesy of AUDI OF AMERICA, LLC

-- Remove the screws -arrows- from the ignition coils.

Fig 3: Identifying Ignition Coil Stage Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Remove the ignition coils carefully.

NOTE:

Note The Installed Position Of Ignition Coils With Power Output Stages.

Be careful to not kink or damage the wiring.

-- Remove spark plugs using spark plug wrench:VAS 3122B .