Version 1 Removing

WARNING: This page is about a different variant/trim than selected.

-- Remove the engine cover. Refer to ENGINE COVER, REMOVING .

-- Remove the screws -1- from the connector strip.

Fig 1: Identifying Bolts And Connectors

Courtesy of AUDI OF AMERICA, LLC

-- Push the connector -2- toward the ignition coil, open the retainer by hand and disconnect the connector.

-- Place the ignition coil puller:T40039 only on the top rib -arrow- and pull the ignition coils one after the other off the spark plugs.

Fig 2: Identifying Ignition Coil Puller - T40039-

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Note The Installed Position Of Ignition Coils With Power Output Stages.

Be Careful To Not Kink Or Damage The Wiring.

-- Remove spark plugs using spark plug wrench:VAS 3122B .