Raising Vehicle: Notes
- Before driving on to a lifting platform ensure there is sufficient clearance between low lying vehicle components and lifting platform.
- Before driving a vehicle onto a lifting platform it must be ensured that the vehicle weight does not exceed the permissible lifting capacity of the platform.
- To prevent damage to the underbody or to prevent the vehicle from tipping, lift the vehicle only at the mounting points.
- Make sure that side member stiffener contacts support plate of lifting platform at center.
- Never start engine and engage a gear with vehicle lifted so long as even one wheel has contact with the floor! There is a risk of an accident if this is not observed!
- Use additional support blocks if it is necessary to work underneath the vehicle.
Vehicle Lifting Mode On Vehicle With Air Suspension
Before Lifting Vehicle With Vehicle Jack Or Lift, Vehicle Lifting Mode Must Be Activated So That The Automatic Air Suspension Regulating Process Does Not Make Lifting With Vehicle Jack Or Lift More Difficult.
Vehicle lifting mode automatically switches off when vehicle speed exceeds 15 km/h.
When vehicle lifting mode is activated, the indicator light in the instrument cluster comes on.
Switching On
-- Turn on the ignition.
-- Press the "CAR" button until the main menu for "adaptive air suspension" appears.
-- Press "SETUP". "adaptive air suspension" menu appears.
-- Turn the control knob to the desired mode and select "ON".
Switching Off
-- Turn on the ignition.
-- Press the "CAR" button until the main menu for "adaptive air suspension" appears.
-- Press "SETUP". "adaptive air suspension" menu appears.
-- Turn the control knob to "vehicle lift mode" and select "OFF" to turn off the vehicle lift mode.
Using the workshop hoist
Always Use A Suitable Rubber Or Wooden Block Between The Jack And The Vehicle.
Do not lift the vehicle at the engine oil pan, transmission, or on front or rear axles as serious damage may result.
-- Set the parking brake so that the vehicle cannot roll away.
-- Engage a gear or move the selection lever into P.
Hoist And Floor Jack Lifting Points