Overview - Dynamic Steering
WARNING: This page is about a different variant/trim than selected.
NOTE:
Additional information on dynamic steering can be found in Self Study Program 402 Audi Dynamic Steering.
- Power Steering Pump
- Only for vehicles with hydraulic power steering
- With an electric control valve
- The control valve is only installed on vehicles with 6- and 8-cylinder engines.
- The power steering pump and control valve are one component and are replaced together.
- On 4- and 6-cylinder vehicles: installed on the front of the engine on the left side (belt drive)
- On 8-cylinder vehicles: installed on the back of the engine on the left side (chain drive)
- Actuator
- Must not be loosened or removed from the steering column.
- The actuator and steering column are one component and are replaced together.
- The system must be calibrated if the actuator is replaced. Refer to DYNAMIC STEERING BASIC SETTING .
- Removing and installing. Refer to STEERING COLUMN, REMOVING AND INSTALLING .
- Active Steering Control Module -J792-
- The system must be calibrated if the Active Steering Control Module -J792-. Refer to DYNAMIC STEERING BASIC SETTING .
- Removing and installing. Refer to Active Steering Control Module -J792-, REMOVING AND INSTALLING .