Adaptive Cruise Control Sensor -G550-, REMOVING AND INSTALLING: Installing

WARNING: This page is about a different variant/trim than selected.

Installation is the reverse of removal, with special attention to the following:

NOTE:

The stud bolts in the bracket are preset. If necessary, correct the setting.

-- Place the Adaptive Cruise Control Sensor -G550- on a soft, clean cloth.

Measure Dimension a of All Studs.

Fig 1: Identifying Dimension -A- To All Studs

Courtesy of AUDI OF AMERICA, LLC

Dimension -a- must be 43 mm.

-- Insert bracket and tighten bolts.

-- Inset the Adaptive Cruise Control Sensor -G550- and carefully push the nuts onto the threaded pins in the sensor.

RS Models:

-- Install the air guide to the coolant auxiliary cooler. Refer to AUXILIARY COOLER, REMOVING AND INSTALLING [For engine(s) CFSA] .

-- Install the front bumper cover. Refer to FRONT BUMPER .

All Models:

-- Install the air intake grille. Refer to FRONT BUMPER .