ACC, CALIBRATING, CALIBRATION PROCEDURE WITH ACC Setting Device:VAS6190: Notes
WARNING: This page is about a different variant/trim than selected.
Special tools and workshop equipment required
- Vehicle Diagnostic Tester
- ACC Setting Device:VAS6190
- ACC Adjuster:VAS6190/2
- Wheel Alignment Computer
NOTE:
The :VAS6190 may have to be adapted for the adjustment procedure. Refer to Setting Device Basic Set .
Before driving the vehicle onto the alignment stand, check if there is enough space between the vehicle and the :VAS6190 . The distance between the :VAS6190 and the vehicle must be 120 cm ± 5 cm.
If there is not enough space, drive vehicle the backward on the alignment stand in order to be able to use the space.
- Before beginning the adjustment, check the DTC memory and correct any malfunctions present.
The calibration procedure is described here using the :VAS6190 . However the :VAS6041 and the :VAS6041/1 can also be used.
NOTE:
Do not perform the steps under "Calibration procedure without a previous axle alignment" if an axle alignment has already been performed.