Wheel Bearing Unit: Installing

WARNING: This page is about a different variant/trim than selected.

Install in reverse order of removal. Note the following:

Tightening specifications, refer to WHEEL BEARING HOUSING AND WHEEL BEARING UNIT OVERVIEW .

-- Install the drive axle. Refer to DRIVE AXLE .

-- Tighten wheel. .

-- On vehicles with automatic headlamp range control system, perform a basic setting on the headlamps. .

-- If the vehicle level sensor was removed and installed on a vehicle with electronically controlled damping or if the linkage was loosened, the control position must be reprogrammed. Refer to CONTROL POSITION, PROGRAMMING USING VEHICLE DIAGNOSTIC TESTER .

-- If the control position was reprogrammed on vehicles with lane assist, the directional stabilization assistance control module -J759- must be recalibrated. Refer to LANE ASSIST CALIBRATION PROCEDURE .