Wheel Bearing Housing: Notes
WARNING: This page is about a different variant/trim than selected.
NOTE:
Two different wheel bearing housings were installed in production; the difference between the two is the steering arm strength. Refer to the Parts Information..
When exchanging the wheel bearing housing, make sure the length of the thread on the tie rod end is sufficient (there must be approximately 5 mm extra thread). If this is not the case, then install a new tie rod end with a longer thread pin. Refer to the Parts Information..
Distinguishing characteristic, refer to WHEEL BEARING HOUSING AND WHEEL BEARING UNIT OVERVIEW .
Special tools and workshop equipment required
- Torque wrench:V.A.G 1331
- Torque wrench:V.A.G 1332
- Ring Spanner Insert VAG 1332/10:V.A.G 1332/10
- Ring spanner insert:V.A.G 1332/7