Mounting Installation Location

WARNING: This page is about a different variant/trim than selected.

Fig 1: Mounting Installation Location

Courtesy of AUDI OF AMERICA, LLC

A = ~ 90° +/- 5°

-- Lightly coat the bearing with fitting paste. Refer to the Parts Information..

-- Insert bearing -1- into track control arm -2-.

Fig 2: Insert Bearing Into Track Control Arm

Courtesy of AUDI OF AMERICA, LLC

-- Install the special tools as shown in the illustration.

NOTE:

When installing, make sure the bearing does not tilt.

-- Press bearing -3- into track control arm -4-.

-- Note the installation depth marking when installing -arrow-.

-- Check rim offset of bearing -1- in track control arm -2-.

Fig 3: Checking Press-In Depth Of Bonded Rubber Bushing

Courtesy of AUDI OF AMERICA, LLC

Dimensions -a- and -b- must be identical.

-- If dimensions -a- and -b- are different, press the bearing -1- in more.

-- Install track control arm. Refer to TRACK CONTROL ARM .