Guide Link: Removing

-- Remove the wheel.

-- Remove noise insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING .

-- Remove the diagonal brace, if equipped. Refer to DIAGONAL BRACE, CABRIOLET .

-- Remove the bolts -arrows- and move the subframe shield -1- to the side, where applicable.

Fig 1: Identifying Subframe Shield

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nut from the guide link joint pins enough so it is flush with the joint pin threads. Counterhold the joint pins if necessary.

To protect thread, screw nut on pin a few turns.

Fig 2: Identifying Bolt -1-

Courtesy of AUDI OF AMERICA, LLC

-- Press linkage stub of guide control arm off conical seating using :T40010 A  .

-- Remove the bolt -1-.

Fig 3: Guide Link & Fasteners

Courtesy of AUDI OF AMERICA, LLC

-- Remove guide link.