Mounting Bracket Installation Position

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Spring Mounting Tool V.A.G 1752/2

Courtesy of AUDI OF AMERICA, LLC

-- Install the :V.A.G 1752/2 as shown in the illustration.

:V.A.G 1752/18-3
:V.A.G 1752/19
:V.A.G 1752/2
:V.A.G 1752/19-1

-- Tension the suspension strut with spring compressor vertically in the :V.A.G 1752/2 .

-- Tension the suspension strut so the pin -1- engages in the clamping jaw opening -2-.

Fig 2: Tension Suspension Strut So Pin Engages In Clamping Jaw Opening

Courtesy of AUDI OF AMERICA, LLC

-- When tensioning, make sure the front damping adjustment valve -1- or electrical wiring connection -2- does not sit on the suspension strut mount -3-.

Fig 3: Identifying Front Damping Adjustment Valve -1-, Electrical Wiring Connection -2- & Suspension Strut Mount -3-

Courtesy of AUDI OF AMERICA, LLC

-- Disengage the locking lever and set the pointer to the 0° position -arrow-, then tighten the locking lever.

Fig 4: Disengaging Locking Lever And Set Pointer To 0 Degrees Position And Seizing Locking Lever

Courtesy of AUDI OF AMERICA, LLC

-- Adjust the mounting bracket so the :V.A.G 1752/19 for the respective side of the vehicle can be bolted to the mounting bracket.

Left Side

Fig 5: Bolt Adjust Gage For Suspension Strut V.A.G 1752/19 Onto Mounting Bracket

Courtesy of AUDI OF AMERICA, LLC

-- Bolt :V.A.G 1752/19 onto mounting bracket -arrows L-.

Right Side

Fig 6: Attach Adjust Gage For Suspension Strut V.A.G 1752/19 To Mounting Bracket

Courtesy of AUDI OF AMERICA, LLC

-- Attach the :V.A.G 1752/19 to mounting bracket -arrows R-.

-- Release the tension in the :V.A.G 1752/1 and remove it.

NOTE:

When releasing the tension, make sure the ends of the spring lie on the spring support stops in the mounting bracket and the lower spring support.

-- Check adjustment, repeat procedure if necessary.

Permissible deviation: ±2°