Tripod Roller Star, Pressing Onto Drive Axle

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Joint And Triple Roller Star Splines

Courtesy of AUDI OF AMERICA, LLC

The chamfer on the triple roller star faces the drive axle. This is used as an assembly aid.

-- Before installing joint or triple roller star, splines -A- must be lightly coated with grease used in joint.

-- Place triple roller star on shaft according to marking and drive on until impact.

Use the :T10065/6 . Make sure it attaches to the bead at the bottom -arrow- in the drive axle.

Fig 2: Identifying T10065/6 And Making Sure It Attaches To Bead At Bottom In Drive Axle

Courtesy of AUDI OF AMERICA, LLC

-- Use special tool shown in illustration.

:T10065/1
The :T10065/6 must attach to the bead at the bottom of the drive axle -arrow-.
:VW 401
:VW 416 B
:VW 447 H
:VW 411
:VW 402

The :T10065/6 must not touch the roller; move the rollers to the side if necessary.

-- Install circlip.

Fig 3: Removing/Installing Circlip

Courtesy of AUDI OF AMERICA, LLC

-- Circlip must engage audibly, triple roller star must lie against circlip with no gap.

1 - Pliers (commercially available)

-- Press approximately 60% of the joint grease, from the repair set, into the back of the triple roller joint.

-- Lightly grease the roller body.

Make sure roller body does not tilt!

-- Press the joint over the triple roller star using a plastic hammer.

Fig 4: Pressing Joint Over Triple Roller Star Using Plastic Hammer

Courtesy of AUDI OF AMERICA, LLC

Drive axle AAR 3300 i :T40018 is shown in illustration.

-- Press remaining quantity of grease in protective boot.

-- Make sure the protective boot is seated on the joint correctly.

-- Protective joint boot must fit in groove and on joint contour.

-- Position joint in center position. See the min - max position.

Fig 5: Identifying Triple Roller Joint Positioned Approximately In Middle Of Sliding Part

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Vent CV boot -arrow-, e.g. using a screwdriver, while positioning joint piece in center position.

-- Install clamp.

NOTE:

For a better alignment of multi-point socket head bolts when installing drive axle, clamping sleeve connecting tube -2- must be between joint connecting flanges -1-.

Fig 6: Identifying Clamping Sleeve Connecting Tube & Flanges

Courtesy of AUDI OF AMERICA, LLC

-- Install the clamps on the triple roller joint. Refer to LARGE AND SMALL CLAMPS, CLAMPING ON INNER OR OUTER JOINT .