Threaded Connection Between Drive Axle And Wheel Hub, Loosening And Tightening: Tightening

WARNING: This page is about a different variant/trim than selected.

Fig 1: Drive Axle Hex Bolt

Courtesy of AUDI OF AMERICA, LLC

-- Replace bolt -arrow-.

NOTE:

Before installing, clean the threads in the CV joint with a tap.

Wheels must not yet touch the ground to tighten the drive axle, wheel bearing may otherwise be damaged.

-- Operate brake (second mechanic required).

-- Tighten bolt to 200 Nm.

-- Lower the vehicle onto its wheels.

-- Tighten bolt an additional 180°.