LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 41 (Wheels, Tires, Wheel Alignment (Wheel And Tire General Information) (Coupe)) >> 44 Wheels, Tires, Wheel Alignment >> Vehicles With Break-Down Kit >> Tires, Mounting

Tires, Mounting

WARNING: This page is about a different variant/trim than selected.
WARNING:

If tire sealant was used, then the wheel electronics on that particular wheel must be replaced.

-- After using tire sealing liquid, wheel electronics must be replaced, since there is the possibility of incorrect measurements due to liquid deposits on pressure sensor.

-- Insert a new tire valve.

-- Remove the valve insert.

-- Inflate tire to approximately 3 to 4 bar (43.5 to 58 psi), tire bead must audibly slide over rim hump.

-- Install valve insert.

-- Correct inflation pressure to the specified pressure.

-- Balance wheel.

scientia non olet · About LEMON Manuals