Wheel Electronics, New Design
WARNING: This page is about a different variant/trim than selected.
Special tools and workshop equipment required
- Torque Wrench 1410:VAG1410 and Torque Wrench 1410 Insert - Accessory Kit:VAG1410/1
Union nut 4 Nm
-- Fold the valve -1- downward -arrow A- towards -arrow B-.
-- Slide the valve with the wheel electronics attached through the valve opening in the rim.
-- Rotate the union nut -arrow 2- three turns on the valve -arrow 1-.
-- Tighten the union nut -2- until the bar breaks with an audible snap.
NOTE:
Press the wheel electronics -1- firmly on the rim well at the same time so that it rests securely on the rim well.
-- Tighten the union nut to 4 Nm.