Wheel Electronics System (Tire Pressure Monitoring System), BERU
WARNING: This page is about a different variant/trim than selected.
Special tools and workshop equipment required
- Torque Wrench 1410:VAG1410 and Torque Wrench 1410 Insert - Accessory Kit:VAG1410/1
WARNING:
If tire sealant was used, then the wheel electronics on that particular wheel must be replaced.
WARNING:
Damaged wheel electronics must be replaced.
-- Push the wheel electronics -1- into the bed.
-- Install on the valve from the back with a microencapsulated screw
NOTE:
Replace the microencapsulated screw.
Tighten the microencapsulated screw to 4 Nm on all models.
Tightening specification for all models: 4 Nm