LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 41 (Wheels, Tires, Wheel Alignment (Wheel And Tire General Information) (Coupe)) >> 44 Wheels, Tires, Wheel Alignment >> Balancing >> Tire And Wheel Radial And Lateral Run-Out

Tire And Wheel Radial And Lateral Run-Out

WARNING: This page is about a different variant/trim than selected.

Radial and lateral run-out occur when the wheel and tire are not running precisely true.

For technical reasons, 100% true running is not possible.

Therefore the manufacturers of these components allow a precisely specified tolerance.

Mounting the tire in a unfavorable position on the wheel can be the cause for exceeding the maximum allowed tolerance for wheel with tire.

The table shows the maximum permissible tolerance values for the wheel with mounted tire.

Tolerances for radial and lateral run-out of disc wheel with tire.

Wheel with tire Radial Run-Out Lateral Run-Out
All 0.8 mm 0.9 mm
scientia non olet · About LEMON Manuals