Powertrain Overview
WARNING: This page is about a different variant/trim than selected.
NOTE:
The -arrows- point in direction of travel.
- Engine
- Drive Plate
- With a needle bearing for the input shaft bearing
- Clutch Module
- Consists of the pressure plate, clutch disc and dual mass flywheel with transfer plate
- Front Differential
- Driveshaft (main shaft)
- Front Drive Pinion with Side Shaft
- Output Shaft
- Manual Transmission
- Center Differential
- Driveshaft
- Rear Pinion
- Rear Differential
- I - 1st Gear
- II - 2nd Gear
- III - 3rd Gear
- IV - 4th Gear
- V - 5th Gear
- VI - 6th Gear
- R - Reverse Gear
- S - Intermediate Drive Gears
- With beveloid splines
- A1 - Front Final Drive
- A2 - Rear Final Drive