Level Control System Control Module -J792-: Removing

WARNING: This page is about a different variant/trim than selected.

NOTE:

The Active Steering Control Module -J792- Is Located In The Footwell Under The Driver Seat.

Before Removing Control Module, Read Out Code Using Guided Fault Finding In "Replace Control Module" Function.

-- Loosen The Driver Seat And Slide It Back With The Wires Connected.

-- Remove The Sill Panel Strip. Refer to the appropriate service information, see SILL PANEL [COUPE] or SILL PANEL STRIP, REMOVING AND INSTALLING / .

-- Remove The Foot Rest. Refer to FOOT REST, REMOVING AND INSTALLING .

-- Disengage The Carpet And Support It Using A Suitable Wood Block -6-.

Fig 1: Disengage Carpet And Support It Using A Suitable Block Of Wood

Courtesy of AUDI OF AMERICA, LLC

-- Remove Nuts -7-.

-- Remove The Nuts -1- And Remove The Ground Wire -2- From The Threaded Pin.

-- Carefully Disconnect The Wiring Harness Clip Connection -3- From The Bracket -4-.

-- Remove The Wiring Harness Connectors -3- From The Control Module -8-.

-- Remove The Bolts -5- From The Control Module -8- And Remove The Bracket -4-.