Rear Axle Toe, Adjusting
WARNING: This page is about a different variant/trim than selected.
Special Tools And Workshop Equipment Required
- Ring Spanner Insert AF 21:T40183
- No Illustration, Commercially Available Pawl With Fine Gear
-- Remove The Nut -A- Of Threaded Connection Tie Rod/Subframe, And Screw On New Nut Until Stop.
-- Adjust Toe By Turning Eccentric Bolt -B-.
Wheel Alignment Specified Values, Refer To WHEEL ALIGNMENT SPECIFIED VALUES .
-- Tighten The Nut -A- Using The :T40183 (95 Nm) .
-- After Tightening Nut -A-, Check Toe Value Once More. Refer To WHEEL ALIGNMENT SPECIFIED VALUES .
NOTE:
The Maximum Adjustment Range Is 90° To Left Or Right Of Center Position.
The Geometric Drive Axle Is Automatically Changed When Individual Toe Settings Are Changed.