Dynamic Steering Overview
WARNING: This page is about a different variant/trim than selected.
NOTE:
Additional Information On Dynamic Steering Can Be Found In Self Study Program No. 402 Audi Dynamic Steering.
- Power Steering Pump
- With An Electric Control Valve
- The Control Valve Is Only Installed On Vehicles With 6- And 8-Cylinder Engines.
- The Power Steering Pump And Control Valve Are One Component And Are Replaced Together.
- Installation Location In Vehicles With 4 And 6-Cylinder Engines: On The Front Left Of The Engine (Belt Drive).
- Installed Location On Vehicles With An 8-Cylinder Engine: Installed On The Back Of The Engine On The Left Side (Chain Drive).
- Actuator
- Must Not Be Loosened Or Removed From The Steering Column.
- The Actuator And Steering Column Are One Component And Are Replaced Together.
- The System Must Be Calibrated If The Actuator Is Replaced. Refer To DYNAMIC STEERING BASIC SETTING .
- Removing And Installing, Refer to the appropriate service information, see STEERING COLUMN.
- Active Steering Control Module -J792-
- The System Must Be Calibrated If The Active Steering Control Module -J792- Is Replaced. Refer To DYNAMIC STEERING BASIC SETTING .
- Removing And Installing, Refer To LEVEL CONTROL SYSTEM CONTROL MODULE -J792- .