Overview - Spoiler

WARNING: This page is about a different variant/trim than selected.

CAUTION:

The adjusting elements and screws for securing the spoiler must always be replaced when replacing the spoiler.
The water drain hoses must be replaced when removing and installing the drive unit.

Fig 1: Identifying Rear Spoiler Assembly Overview RS5

Nut
- 2 Nm
- Quantity: 16
Lower Right Water Drain Hose
- For the rear lid
- Removing and installing. Refer to LOWER REAR LID TRIM PANEL, REMOVING AND INSTALLING .
Upper Right Water Drain Hose
- Replace
- Mount with drive unit
- Removing and installing. Refer to UPPER WATER DRAIN HOSE FOR DRIVE UNIT, REMOVING AND INSTALLING .
Mount with Drive Unit
- For the rear spoiler
- With Rear Spoiler Motor -V52- , Rear Spoiler Stop Switch 1 -F135- , Rear Spoiler Stop Switch 2 -F136-
- Removing and installing. Refer to MOUNT WITH SPOILER DRIVE UNIT, REMOVING AND INSTALLING .
Stop
- Quantity: 3
- Self-adhesive
Intermediate Piece
- For the adjusting mechanism
Right Adjusting Mechanism
- Replace
- For balancing out differences in height
Spoiler
- Removing and installing. Refer to SPOILER, REMOVING AND INSTALLING .
Left Adjusting Mechanism
- Replace
- For balancing out differences in height
Intermediate Piece
- For the adjusting mechanism
Bolt
- 9 Nm
- Replace
- Quantity: 4
Upper Left Water Drain Hose
- Replace
- Mount with drive unit
- Removing and installing. Refer to UPPER WATER DRAIN HOSE FOR DRIVE UNIT, REMOVING AND INSTALLING .
Lower Left Water Drain Hose
- For the rear lid
- Removing and installing. Refer to LOWER REAR LID TRIM PANEL, REMOVING AND INSTALLING .