LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 38 (Exterior Equipment (Coupe)) >> 66 Exterior Equipment >> Roof Bars/Roof Rails >> Overview - Roof Trim Molding

Overview - Roof Trim Molding

WARNING: This page is about a different variant/trim than selected.
NOTE:

To remove roof trim molding, it is not necessary to remove the side window.

Fig 1: Identifying Roof Trim Molding
GWWA66-10277
  1. Roof Trim Molding
    NOTE:

    Roof trim molding must not be twisted or bent.

    -- Remove the door seal from the body flange in the >>A-pillar<< and roof trim molding area.

    -- Drill off rivet heads of pop rivets, strike rivet shafts through and remove roof trim molding.

    -- Carefully pry the roof trim molding out of clips over the side window and remove it.

  2. Side Window
  3. Trim Strip

    -- To remove the >>B-pillar<< , pry it out of the clips on the roof beginning at the side.

    -- Pry out the side trim strip on the side panel out of the clips.

    -- Slide the trim molding down out of the roof trim molding.

  4. Blind Rivet
    • Quantity: 9 on the roof trim molding.
scientia non olet · About LEMON Manuals