LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 38 (Exterior Equipment (Coupe)) >> 66 Exterior Equipment >> Molding/Trim/Extensions/Trim Panels >> Sill Panel Trim, Removing And Installing >> Overview

Sill Panel Trim, Removing And Installing: Overview

WARNING: This page is about a different variant/trim than selected.
NOTE:

The sill panel strip is secured to the side member using adhesive strips.

It is not possible to remove without destroying.

Fig 1: Identifying Outer Sill Panel Strip
GWWA66-10275
  1. Door Seal
  2. Sill Panel Strip
    • Removing:

      -- Heat the sill panel strip using a hot air gun and pull the molding upward and off.

    • Installing:

      -- The side member must be free of dirt and grease in the adhesive area.

      -- Heat the adhesive surface to approximately 40 °C (104 °F) with a hot air blower.

      -- Remove protective film from adhesive tape.

      -- Insert the sill panel strip with the centering pins in the side member and press it on firmly in stages from front to back.

  3. Adhesive Tape
    • Pull off protective foil before installing.
scientia non olet · About LEMON Manuals