Backrest Heating Element, Removing And Installing: Installing
WARNING: This page is about a different variant/trim than selected.
-- Align The New Backrest Heating Element On The Padding.
CAUTION:
- Make Sure The New Seat Heating Element Is Affixed To The Old Heating Element.
- Remove The Protective Films In The Bonding Sequence For The Heating Element Area.
- When Removing The Protective Film, Make Sure The Heating Element Is Not Damaged And That It Is Attached Without Wrinkles.
-- Begin Bonding The Center Are Of The Backrest Heating Element -arrow C-.
-- Then Bond The Top Area -arrow A-.
-- Route The Connecting Wires From The Top To The Bottom Heating Surface In The Base Of The Gaps -B Arrows-.
-- Bond The Bottom Area Of The Heating Surface -arrow D-.
-- Pull The Wire -3- Through The Slit In The Padding -arrow E-.
Install In Reverse Order Of Removal.