Driver/Front Passenger Seat Heating Element - Z6- / - Z8-, Removing And Installing, Bucket Seat: Installing

WARNING: This page is about a different variant/trim than selected.

-- Align The New Heating Elements On The Seat Surface.

CAUTION:

Make sure the new seat heating element is affixed to the old heating element.
Remove the protective films in the bonding sequence for the heating element area.
When removing the protective film, make sure the heating element is not damaged and that it is attached without wrinkles.

-- Conduct the electrical connection wire down through the opening provided in the seat cushion.

-- Remove the protective film and adhere new heating elements -1, 2, 3, 4, 6- to the same positions as the old heating elements.

-- Run connecting wires -A- loosely to the seat bolsters along the bottom of the gaps.