Steering, Centering, Hydraulic Power Steering Gear

WARNING: This page is about a different variant/trim than selected.

Affects All Vehicles

NOTE:

Centering the steering is meant only for "aligning" the steering for subsequent work.

The steering wheel center position is determined exactly via the steering angle with the help of the wheel alignment computer.

If a steering wheel fault is determined when setting the center position of the steering, then check the steering and suspension for damage or deformations and replace any damaged components. Check the tie rod symmetry as well. Refer to MAXIMUM STEERING ANGLE, CHECKING .

-- Remove the noise insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING .

-- Bring the steering gear into the center position.

The point -1- must be opposite the marking -2-. The distances of the tie rod ends to the steering gear must be the same at the left and right.

Fig 1: Hydraulic Power Steering Gear Steering, Centering

Courtesy of AUDI OF AMERICA, LLC

NOTE:

These Designations Only Serve To Assist In A General Positioning Of The Steering Center Position.