SERVOTRONIC Solenoid Valve -N119-, Removing And Installing: Installing
WARNING: This page is about a different variant/trim than selected.
Installation Is The Reverse Of Removal, With Special Attention To The Following:
-- Install a new screen -7-.
-- Lightly coat gasket -4 and 5- with Steering Gear Grease and insert.
-- Place the Solenoid Valve -- -3- into the power steering gear -6- as far as the stop. Do not tilt the Solenoid Valve -- when doing so.
CAUTION:
- Always Follow Screw Tightening Sequence.
-- Tighten Screws -1 And 2- As Follows:
- Tighten The Bolt -1- to 0.5 Nm.
- Tighten The Bolt -2- to 1.5 Nm.
- Tighten The Bolt -1- to 3.0 Nm.
- Tighten The Bolt -2- to 3.0 Nm.
-- Steering gear, installing. Refer to STEERING GEAR, REMOVING AND INSTALLING, HYDRAULIC POWER STEERING GEAR .