Overview - Steering Gear, Electro-Mechanical Steering Gear: Notes
WARNING: This page is about a different variant/trim than selected.
- Electro-Mechanical Steering Gear with Tie Rods
- With Power Steering Control Module -J500-
- Removing and Installing. Refer to STEERING GEAR, REMOVING AND INSTALLING, ELECTRO-MECHANICAL STEERING GEAR .
- Servicing. Refer to STEERING GEAR, SERVICING, ELECTRO-MECHANICAL STEERING GEAR .
- There are different versions. Refer to the Electronic Parts Information. (ETKA).
A removable heat shield mat was installed on the steering gear at start of production. Be sure to install this mat if installing the old steering gear again.
A removable heat shield mat on the steering gear was replaced by a bonded heat shield mat as a running change. It is therefore not necessary to take the mat from the old steering gear and install on a new steering gear.
A replacement steering gear comes with the bonded heat shield mat.
- Bolt
- 80 Nm +180°
- Always replace if removed
- Subframe
- Nut
- Always replace if removed
- Pushed into the subframe
- Steering Intermediate Shaft
- Bolt
- Tightening Specification -item ) OVERVIEW - STEERING COLUMN - BOLT.
- Wheel Bearing Housing
- Nut
- Always replace if removed
- There are different versions. Refer to the Parts Information. for the allocation.
- There are different versions and tightening specifications. Refer to OVERVIEW - STEERING GEAR, ELECTRO-MECHANICAL STEERING GEAR