Power Steering Pump, Removing And Installing, 4-Cylinder TFSI, Without Dynamic Steering: Notes

Special Tools And Workshop Equipment Required 

• Hose Clamps - Up To 25 mm:3094 
• Hose Clip Pliers:VAG1275A 
• Torque Wrench 1331 5-50 Nm :VAG1331 
• Used Oil Collection and Extraction Unit:SMN372500 
• Engine Bung Set:VAS6122 
• Shop Crane - Drip Tray:VAS6208 

General Information 

The power steering pump is not designed to be serviced. If there are customer complaints, the cause must be determined using a pressure and leak test. If there is a malfunction, replace the power steering pump.

• If power steering fluid is low in reservoir, check steering system for leaks.
• If there are leaks in the area of the line connections, the lines/connections must first be inspected for leaks, tightened as necessary and wiped dry.
• The power steering pump is delivered without oil. Before installing, fill pump with Hydraulic Fluid and turn pump by hand. Otherwise, the power steering pump may be noisy when operating or may even be damaged.