Hydraulic Fluid Cooler To The Condenser - RS Models

Fig 1: Identifying Hydraulic Fluid Cooler -1- & Bolts -2-

Courtesy of AUDI OF AMERICA, LLC

-- Mount the hydraulic fluid cooler -1- on the retainers and tighten the bolts -2- to 9 Nm.

Lines to the hydraulic oil cooler. Refer to HOSE LINES TO RESERVOIR, HYDRAULIC FLUID COOLER AND RETURN LINE INSTALLED POSITION .

Pressurized Line To Crossbrace 

Fig 2: Identifying Pressurized Line To Crossbrace

Courtesy of AUDI OF AMERICA, LLC

-- Install the pressure line on the crossbrace using the nut -3- and rubber bushing -4-.

-- Note the line installation location when bolting the line connection. The markings -1 and 2- must be opposite each other.

Return Line Bracket To The Subframe 

Fig 3: Return Line Bracket to the Subframe

Courtesy of AUDI OF AMERICA, LLC

-- Secure the return line -2- with the line bracket -1- to the left front of the subframe -3-.

-Arrow- Points In Direction Of Travel.

Return Line To Subframe 

Fig 4: Identifying Return Line To Subframe

Courtesy of AUDI OF AMERICA, LLC

-- Install the return line -4- on the subframe -3- using the bracket -2- and bolt -1-.