Repairing Can Bus Wires

WARNING: This page is about a different variant/trim than selected.

NOTE:

Observe General Notes For Repairs On The Vehicle Electrical System. Refer To VEHICLE ELECTRICAL SYSTEM, GENERAL REPAIR INFORMATION .

Unshielded, Twisted Two-Wire Lines -1 And 2- With A Cross Section Of 0.35 mm ² or 0.5 mm² Can Be Used As CAN-Bus Wiring.

Courtesy of AUDI OF AMERICA, LLC

Repairs On CAN-Bus Wires Can Be Performed With Repair Wire With Matching Cross Section And Also With Twisted Wires "Green/Yellow" Or "White/Yellow" From The Parts Information.
When Repairing CAN Bus Wires, Both Wires Must Be Same Length. When Twisting Together Wires -1 And 2-, The Lay Length Of A = 20 Mm (0.78 In.) Must Be Observed.
While Doing This, No Section Of The Wire, For Example, In Area Of Crimp Connectors -Arrow-, May Be Greater Than B = 50 mm (1.96 in.) Without Twisting Of The Wires.
Wrap Repair Points With Yellow Adhesive Tape To Mark A Performed Repair.