Repair Kit For FLEXRAY Wires Without Coating
WARNING: This page is about a different variant/trim than selected.
NOTE:
Observe General Notes For Repairs On The Vehicle Electrical System. Refer To VEHICLE ELECTRICAL SYSTEM, GENERAL REPAIR INFORMATION .
The Repair Of Flexray Wires Without Coating Can Only Take Place Using Flexray Wires Without Coating From The Parts Information.
Unshielded, Twisted Two-Wire Lines -1 And 2- With A Cross Section Of 0.35 mm 2 Can Be Used As FlexRay Wires.
- During Repair Work, both FlexRay wires must have the same length.
- When Twisting The Wires -1 and 2- Together, The -A- = 20 mm Routing Length Must Be Maintained.
- While Doing So, No Section Of Wire May Be Greater Than -B- = 40 mm Without Twisting The Wires, For Example In The Area Of Crimp Connectors -arrow-.
- Mark The Location Of The Repair With Something Suitable, For Example, With Yellow Tape.
- Repairing Both Flexray Wires Is Identical To Repairing Just One Wire.
- Position Both Repaired Locations -A- = 20 mm Opposite Each Other.
- Crimp The Cables With Connectors.
1 - Repair Location In Wiring Harness
2 - Repair Location With Connectors