Repair Kit For FLEXRAY Wires With Coating
WARNING: This page is about a different variant/trim than selected.
NOTE:
Observe General Notes For Repairs On The Vehicle Electrical System. Refer To VEHICLE ELECTRICAL SYSTEM, GENERAL REPAIR INFORMATION .
The Repair Of Flexray Wires With Coating Can Only Take Place Using Flexray Wires With Coating From The Parts Information.
A Two-Layer Wire -1 and 2- With A 0.35 mm 2 Profile Is Used As A Flexray Wire.
- During Repair Work, Both Wires Must Have The Same Length.
- When Twisting The Wires -1 And 2- Together, the -A- = 30 mm (1.18) Routing Length Must Be Maintained.
- While Doing So, No Section Of Wire May Be Greater Than -B- = 50 mm (1.96 in.) Without Twisting The Wires, For Example In The Area Of Crimp Connectors -arrow-.
- Maximum Exposed Wire Length: -C- = 100 mm (3.93 in.).
- Protect The Area Being Repairs From The Environment. Use A Crimp Connector With Heat-Shrinkable Tube Over The Untwisted Location Being Repairs And Waterproof Insulation Over The Exposed Wire.
- Mark The Location Of The Repair With Something Suitable, For Example, With Yellow Tape.
- Repairing Both Wires Is Identical To Repair Just One Wire.
- Position Both Repaired Location -arrows- -A- = 30 mm (1.18) Opposite Each Other.
- Crimp The Cables With Connectors.
1 - Repair Location In The Area Without Insulation
2 - Repair Location With Connectors
C - Maximum Exposed Length = 100 mm (3.93 in.)