Fiber-Optic Cable, Preparing With The Fiber-Optic Conductor Repair Set :Vas6223A: Stripping

Courtesy of AUDI OF AMERICA, LLC

-- Open the :VAS6223/1  .

• Stripping lever must be in lower position -arrow-.

-- Place the fiber optic cable -1- in the stripping point.

• The end of the fiber-optic cable must be flush with the rear side of the cutting pliers.

-- Close :VAS6223/1  until stop and keep closed.

Courtesy of AUDI OF AMERICA, LLC

-- Lift the stripping lever -arrow- upward.

-- Open the cutting tool and take out the fiber-optic cable -1-.

-- Detach the separated section of the insulation from the fiber-optic cable.

Precision Cutting (Production Of Optical End Face)

Courtesy of AUDI OF AMERICA, LLC

-- Slide the fiber-optic cable -1- into the cutting station.

• The insulation must make contact with the cutting point stop -arrow-.

-- Close the :VAS6223/1  .

-- Press the cutting unit down -arrow-.

Courtesy of AUDI OF AMERICA, LLC

-- Open :VAS6223/1  and remove fiber-optic cable -1-.

Courtesy of AUDI OF AMERICA, LLC

-- Open The :VAS6223/1  .

-- Position The Wire Stripper In The Lower Position -arrow-.

-- Insert Fiber-Optic Cable Into The Stripping Station.

• The End Of The Fiber-Optic Cable Must Be Flush With The Rear Side Of The Cutting Pliers.

-- Close The :VAS6223/1  Until The Stop And Keep Closed.

Courtesy of AUDI OF AMERICA, LLC

-- Bend The Wire Stripper Upward -Arrow- And Remove The Fiber-Optic Cable.

Precision Cutting (Production Of Optical End Face).

Courtesy of AUDI OF AMERICA, LLC

-- Push The Fiber-Optic Cable -1- Into The Cutting Station.

• Insulation Must Make Contact With Cutting Point Stop.

-- Close The :VAS6223/1  And Remove The Wire.

Courtesy of AUDI OF AMERICA, LLC

-- Visually Inspect The Wire -1- To Make Sure That It Was Cut Correctly And That There Are No Burrs On The Front Surface.