Attaching Brass Pin Contact To Fiber-Optic Cable

Courtesy of AUDI OF AMERICA, LLC

-- Open securing lever on :VAS6223/2  -arrow 1- and -arrow 2-.

-- Insert brass pin contact -1- in the mount.

Courtesy of AUDI OF AMERICA, LLC

-- Close the safety lever on the :VAS6223/2  -arrow-.

-- Slide the fiber optic cable -2- into the brass pin contact -1- as far as spring-loaded stop.

Courtesy of AUDI OF AMERICA, LLC

-- Slide fiber-optic cable further in up to fixed stop and close :VAS6223/2  .

-- Open the crimping pliers for fiber-optic cable and remove the fiber-optic cable with the brass pin contact.

-- Make sure the brass pin contact -2- is secured correctly on the fiber-optic cable -1-.

Courtesy of AUDI OF AMERICA, LLC

• Four crimp points must be visible at the brass connection pin.
• The brass pin contact must not be able to be removed by hand from the fiber-optic cable.
• The front surface of the fiber-optic cable is 0.01 to 0.1 mm behind the brass pin contact (visual check).

Courtesy of AUDI OF AMERICA, LLC

-- Change Tool Head -arrow-.

Courtesy of AUDI OF AMERICA, LLC

-- Slide The Safeguard On The :VAS6223/1  -arrow- So That The Word "Stift" (Pin) Is Legible.

-- Insert A Brass Pin Contact -1- In The Mount.

Courtesy of AUDI OF AMERICA, LLC

-- Close The Securing Lever On The :VAS6223/1  -arrow-.

-- Insert The Fiber-Optic Cable Into The Brass Pin Contact -arrow- All The Way Up To The Threaded Stop And Then Close The :VAS6223/1  .

Courtesy of AUDI OF AMERICA, LLC

-- Open The Fiber-Optic Cable Pliers And Remove The Fiber-Optic Cable Along With The Brass Contact Pin.

-- Make Sure The Brass Pin Contact -2- Is Secured Properly On The Fiber-Optic Cable -1-.

Courtesy of AUDI OF AMERICA, LLC

• 4 Crimped Points Must Be Visible On The Brass Connecting Pin.
• The Brass Pin Contact Must Not Be Able To Be Removed By Hand From Fiber-Optic Cable.
• The Front Surface Of The Fiber-Optic Cable Is 0.01 To 0.1 Mm Behind The Brass Pin Contact (Visual Check).