Fiber-Optic Cable, Disconnecting From Wiring Harness Connector: Removing

WARNING: This page is about a different variant/trim than selected.

Courtesy of AUDI OF AMERICA, LLC

-- Unplug Connector For Fiber Optic Cable From Appropriate Control Unit.

-- Release The Catch In The Fiber Optic Cable Connector In Direction Of -Arrow-.

-- Pull The Fiber Optic Cable Basic Module -2- Out Of Connector Housing -1-.

Courtesy of AUDI OF AMERICA, LLC

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

Make Colored Dots To Mark Assignment Of The Fiber Optic Cable -5- To The Corresponding Sockets In The Base Module -1-.
Note the arrows -3- for allocation on the base module "IN" and "OUT".

-- Release The Secondary Catch -6- (Blue Pin) Using A Small Screwdriver -arrow-.

-- Release The Catch -2- And Remove The Fiber-Optic Cable -5- With Brass Connector Pin -4- From The Base Module -1-.