Determine Position Of The Error: Procedure

WARNING: This page is about a different variant/trim than selected.

It Is Very Difficult To Find The Exact Location Of The Problem. Replace The Damaged Fiber-Optic Cable And Lay A New Wire Parallel To The Defective Fiber-Optic Cable.

NOTE:

Via The "Guided Fault Finding" It Can Be Determines Which Component Of The Fiber-Optic Cable Is Damaged.

A Fiber-Optic Cable That Needs Repair Is Represented By A "Yellow" Color.

-- Perform In The "Off-Board Diagnostic Information System Service" The "Ring Break Diagnosis" Function In The Vehicle Diagnostic Tester.

-- Remove The Affected Components.

-- Disconnect The Connector From The Components.

-- Assemble The Fiber-Optic Cable:

Refer to FIBER-OPTIC CABLE, PREPARING WITH THE FIBER-OPTIC CONDUCTOR REPAIR SET
Refer to FIBER-OPTIC CABLE, PREPARING WITH THE FIBER-OPTIC CONDUCTOR REPAIR SET