Determine Position Of The Error: Notes
WARNING: This page is about a different variant/trim than selected.
Special Tools And Workshop Equipment Required
- Vehicle Diagnostic Tester
CAUTION:
Do Not Bend The Fiber-Optic Cable Too Much. The Bending Radius Must Be No Less Than 25 Mm.
Fiber Optic Cables Must Not Be Routed Over Sharp Edges.
The Fiber-Optic Cable Must Not Be Dirty Or Touched With Bare Fingers.
Fiber Optic Cables May Not Be Heated.
It Is Not Permitted To Twist Together 2 Fiber Optic Cables Or One Fiber Optic Cable With A Copper Wire.
Protect The Connector And The Connection Box From Dust. Place The Cap On The Trunk.