Round Connector Systems
If Necessary, Housing Securing Mechanisms (Secondary Locks) Must Be Released Or Removed Using Specified Tool Before Releasing The Contacts. Refer To SECONDARY LOCK .
-- Guide The Release Tool Which Fits The Connector Housing Into Release Channel On Connector Housing.
-- Grasp Contact At Wire And Push It Gently Into Connector Housing In Direction Of -arrow-.
By Pushing The Contact In The Direction Of The Connector Housing, Contact Retaining Tabs Are Lifted Off The Housing Shoulder And Released Using The Release Tool.
-- At The Same Time, Push The Release Tool In The Direction Of The Connector Housing -Arrow- And Pull The Released Contact Out Of The Connector Housing.
-- After Removing The Contact, Release Tool Can Be Pulled Out Of The Connector Housing Again.