Vehicle Diagnostic Tester, Connecting: Procedure
WARNING: This page is about a different variant/trim than selected.
-- Engage the parking brake or operate the electromechanical parking brake.
-- Shift the shifter lever into neutral or place the selector lever in the "P" position.
-- Turn off the ignition and connect the Vehicle Diagnostic Tester to the Data Link Connector (DLC) with the diagnostic cable -arrow-.
-- When using the :VAS5054A or the :VAS5055 pay attention to the Operating Instructions.
-- Turn on the ignition.
-- Turn off all electrical consumers.
NOTE:
If a error message appears on the screen of the Vehicle Diagnostic Tester. Refer to the Operating Instructions.