ESD Work Surface :Vas6613, Using
WARNING: This page is about a different variant/trim than selected.
- The Electro-Static Discharge :VAS6613 Protect Electronic Components From Getting Damaged By An Electro-Static Charge.
- This Makes Is Possible To Perform Repairs On Sensitive Electronic Components On An Open Mat.
- For More Information As To What Work Can Be Performed On The :VAS6613 . Refer To The "Electrical Equipment" information.
-- Place The Electro-Static Discharge Mat -3- From :VAS6613 On A Clean, Dry Table.
-- Connect the Ground (GND) -2- to one of the buttons on the mat.
-- Connect the GND connector adapter -1- to the adapter connector on an outlet with contact protection or connect the alligator clip to a ground in the building or a water pipe.
-- Connect the wrist strap -4- to one of the buttons on the mat.
-- Attach the wrist strap directly to your wrist - never to your shirt sleeve or jacket sleeve.
CAUTION:
If working on especially sensitive electronic component and with the pad exposed, use only non-magnetic tools, for example, a :T10072 .