Relay/Fuse Panel Mount With Vehicle Electrical System Control Module -J519-, Removing And Installing: Installing
WARNING: This page is about a different variant/trim than selected.
Install In Reverse Order Of Removal. Note The Following:
- Tightening Specification. Refer to Figure.
-- Engage The Retaining Pins -1- On The Mount -3- At The Side Guide In The A-Pillar -arrow-.
-- Tighten The Nuts -2-.
-- Install The Air Duct To The Left Instrument Panel Vent. Refer To DRIVER SIDE FOOTWELL VENT, REMOVING AND INSTALLING / OVERVIEW - AIR ROUTING AND AIR DISTRIBUTION IN PASSENGER COMPARTMENT .
-- Install The Left Side Instrument Panel Vent. Refer To INSTRUMENT PANEL VENT, REMOVING AND INSTALLING .